Hematek
®
3000 System – Instruction Manual – Version 1.3104
Power switch with green power
light
The power switch is located on top of the slide stainer, at the right side.
When the main switch, see Main switch on page 4-11, is set to position I and
the power switch is pressed, the green power light in the power switch goes
on, the fan starts and the conveyor spirals slowly revolve. If the power
switch is pressed again, the green power light in the power switch goes off,
and the fan and the conveyor spirals stop.
Yellow low stain light The yellow low stain light is located at the right side of the slide stainer, next
to the rear conveyor spiral and above the red waste tank light. It is off under
normal operating conditions.
When the Hematek Stain Pak is running low, a weight-sensing device
activates the yellow low stain light. You can use the Hematek Stain Pak as
long as no air bubbles appear in any of the pump tubes.
1 Power module
Figure 4-10 Electrical components of the slide stainer, rear view
1 Service button
Figure 4-11 Electrical components of the slide stainer, service button
To Next Page
Loading...
