Siemens HiPath 1100 Series Service Manual

Dial Pulse (DP) and Dual Tone Multifrequency (MF
)
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
5-9
For internal distribution only Telephones
5.3 Dial Pulse (DP) and Dual Tone Multifrequency (MF)
5.3.1 Dial Pulse (DP) Telephone
Analog telephones, wireless telephones, fax machines and any device that uses
pulse dialing. Procedures for using these types of telephones are outlines following
the symbol“DP”.
5.3.2 Dual Tone Multifrequency Telephone (MF)
Analog telephones, wireless telephones, fax machines and any equipment that uses
touch-tone dialing. This dialing mode is recognized by the dual-tone it generates,
which can be heard by the caller on the handset as the numbers are dialed. Proce-
dures for using these types of telephones are outlined following the symbol “DTMF”.
5.3.3 DP/DTMF Telephone Models
Siemens provides DP and MF telephones and many additional features:
● Memory storage of the most frequent numbers dialed
● Key for redialing the last number dialed.
● Microphone Mute Key
● Caller ID, Phonebook, Clock etc.
Note:The Caller ID feature must be provided by a local carrier.
Important
Instructions for the “Flash” feature is valid only for a DTMF telephone. If you have a
touch-tone telephone (MF) that does not feature a “Flash” key, placing the phone
on-hook and off-hook momentarily will simulate the action of the Flash key.
!

Siemens HiPath 1100 Series Specifications

General

Brand	Siemens
Model	HiPath 1100 Series
Category	Telephone
Language	English