Starting the Programming Mode
Operation For internal distribution only
A31003-K1250-S100-12-7619
6-20 HiPath 1100, Service Manual
11. Enter the MSN-CAPI number (see Table 7-2 on page 7-2) in Add, in the Multi-
Subscriber Numbers field.
12. The installation of the USB drivers is now completed. CAPI applications installa-
tion will now start automatically (see “Installing CAPI Applications” on page 6-
23).
Windows XP
Proceed as follows:
1. A window displays a message informing you that new hardware was found. The
"Found New Hardware Wizard" box appears to guide you through the installation
of the drivers. Choose "Install from a list or specific location (Advanced)." Click
"Next" to proceed.
2. Select the "Specify a location:" checkbox, if it is not selected yet, then click "Next."
3. A second window opens. Click Browse to select the directory where the uncom-
pressed CallBridge for Data is stored (e.g., C:\Temp). Click Next to proceed.
4. Once this is completed, the installation of the HiPath 1000 will start. A message
appears (three times) to the effect that the software installation did not pass the
Windows logo test. Click "Continue" every time this message appears.
Figure 6-16 Windows 2000 - MSN
In order to install any software you must have Administrator’s access privileges.
To Next Page
Loading...
Need help?
General