Installation Procedures
Installation For internal distribution only
A31003-K1250-S100-12-7619
4-2 HiPath 1100, Service Manual
4.2 Installation Procedures
Warning
Before installing the equipment, read carefully all information and recommendations
provided in Chapter 1, “Important Information”
When connecting to digital lines of terminals powered by an external AC power
source, the maximum number of terminal equipment allowed is 14 per system. Ex-
ceeding this limit may damage the equipment and present a hazard to the safety of
the user.
Table 4-1 HiPath 1100 - Equipment installation procedures
Step Installation Procedures (Information)
1. “Select the location for installing the equipment”
(Usually already setup)
page 4-4
2. “Unpacking System Components” page 4-4
3. “Getting to Know your Systems” page 4-5
4. “HiPath1120/1130/1150 Wall Mounting Instructions” page 4-8
5. “Installation of Expansion and Option Modules” page 4-16
6. “Connecting Extensions to the System’s Internal MDF (Main
Distribution Frame)”
page 4-32
7. “Installing a V.24 Interface” page 4-38
8. “Installing an USB Interface” page 4-39
9. “Installing an External Audio Source” page 4-40
10. “Installing a TFE - Entrance Telephone Interface” page 4-40
11. “Recommendations concerning the Power Supply and Protec-
tion of the System”
page 4-42
12. “Protective Power Outage Relays” page 4-45
13. “System Cabling” page 4-46
14. “Installing Telephone Terminals” page 4-46
15. “Performing a Visual Inspection” page 4-48
!
To Next Page
Loading...
Need help?
General