Siemens HiPath 4000 - Using Signal Call; Placing a Messenger Call; Defining a Representative for the Secretary

Making calls in an executive-secretary team
131
Step by Step
Using signal call
If a "Buzz" programmed sensor key is configured on
your executive phone, you can press a key to send a sig-
nal call to a specific destination phone (e.g. to a secre-
tary phone). On the destination phone, the phone num-
ber of the transmitting phone is also briefly displayed for
the signal call.
You can press the programmed sensor key in idle mode
and while on a call (once or several times).
If a "Buzz" programmed sensor key is not configured,
you can lift the handset and enter the "Signal call" code
to send a signal call to the destination phone.
Placing a messenger call
You can place a messenger call by pressing a key, if this
key is configured on the executive phone. Programming
a sensor key with a function Æ page 83.
Defining a representative for the
secretary
Calls for the executive that arrive at the secretary phone
can be forwarded to another phone. To do this, you
must configure a "Alt. Answer" programmed sensor key
Æ page 83.
Activating the representative:
S Press the "Alt. Answer" programmed sensor key. The
LED lights up.
Deactivating the representative:
R Press the "Alt. Answer" programmed sensor key. The
LED goes out.