Siemens HiPath 4000 - Configuring repdial keys

Step by Step
Programming sensor keys
84
Configuring repdial keys
You can program repdial keys with external phone num-
bers on two levels. To program the second level, you
must configure a "Shift" key Æ page 83.
See also Æ page 19.
You must first program a sensor key with the repdial
function.
Then you must define the phone number and label.
Programming a sensor key as a repdial key
v Open the Program/Service menu Æ page 37.
Select and confirm the option shown.
S Press the required sensor key.
Confirm the option shown.
Select and confirm the option shown.
Confirm the option shown.
The sensor key is now defined as a repdial key.
Confirm the option shown.
Confirm the option shown.
Select and confirm the option shown.
S Press the saved repdial key.
Defining the phone number
j Enter the station number.
or
Confirm the option shown. Your entry is saved.
Key function?
Change?
Repdial?
Save?
R
Service Menu
Destinations? g
Repdial?
At this point, you can enter additional functions
Æ page 85.
Completed?