Siemens HiPath 500 - Using System Functions from Outside DISA (Direct Inward System Access)

More functions/services
97
Step by Step
Using system functions from outside
DISA (direct inward system access)
If configured (contact your service personnel), you can
use an external phone like an internal station to set up
an outgoing external connection via the system. You
can also activate or deactivate the following system
functions:
• Reset services and functions,
code #0 Æ page 95
• Call forwarding, code
*
1/#1 Æ page 41
• Lock and unlock phone,
code
*
66/#66 Æ page 86
• Save your PIN,
code
*
93 Æ page 88
• Send a message,
code
*
68/#68 Æ page 90
• Leave an advisory message,
code
*
69/#69 Æ page 92
• Ringing group, code
*
81/#81 Æ page 112
• Group call, code
*
85/#85 Æ page 112
• Caller ID suppression,
code
*
86/#86 Æ page 84
• Camp-on tone, code
*
87/#87 Æ page 61
• Open door, code
*
61 Æ page 48
• Release door opener, code
*
89/#89 Æ page 49
• Control relays, code
*
90/#90 Æ page 101
• Do not disturb, code
*
97/#97 Æ page 83
• Ringer cutoff, code
*
98/#98 Æ page 83
• Dial using speed dial, code
*
7 Æ page 55
• Associated service, code
*
83 Æ page 96
Prerequisite: Your phone supports tone dialing (DTMF)
or you can switch your phone to tone dialing. The phone
is not connected to the system.
j Establish a connection to the system. Enter the station
number (contact your service personnel).
j Wait for the continuous tone (if necessary, switch
phone to tone dialing) and enter the internal number as-
signed to you and the corresponding PIN.
( Enter the code (only required if programmed in the sys-
tem).