Siemens IM 151-7 - Page 40

Getting Started
2-14
ET 200S IM 151-7 CPU Interface Module
A5E00058783-04
Se-
quence
ResultAction
7  In the bottom left-hand part of the Hardware
Configuration Program window, double-click
on CPU 315-2 DP (line 2).
 In the window that then appears, click on the
Properties button on the General tab.
 In the ”MPI Network” window that then
appears, check whether the address is set to
2. If not, set the address.
Confirm with OK.
8 In the catalog, navigate through PROFIBUS-DP to Configured Stations.
Drag and drop the ET 200S/CPU onto the PROFIBUS Master System.
9 In the window that then appears, click on the Interconnect button. The Properties – MPI/DP
window appears.