Siemens IM 151-7 - Network Components

ET 200S in the PROFIBUS Network
4-6
ET 200S IM 151-7 CPU Interface Module
A5E00058783-04
4.2 Network components
To connect the ET 200S to the PROFIBUS-DP network, you need the following
network components:
Table 4-2 Network components
Purpose
Network components Order numbers
To set up the network Cables (e.g. 2-core,
shielded or 5-core,
unprepared)
6XV1 830-0AH10
(2-core)
6XV1 830-0BH10
(2-core with PE sheath)
6XV1 830-3CH10
(2-core, for festoon
attachment)
6XV1 830-3BH10
(drum cable)
6XV1 830-3AH10
(direct-buried cable)
6ES7 194-1LY00-0AA0-Z
(5-core with PVC sheath)
6ES7 194-1LY10-0AA0-Z
(5-core; oil-resistant, can be
dragged, conditionally
resistant to welding; with PUR
sheath)
To connect the PD and the
ET 200S on the
PROFIBUS-DP network
Bus connector without a PD
socket (up to 12 Mbaud)
6ES7 972-0BA10-0XA0
(with a straight outgoing cable
unit)
6ES7 972-0BA40-0XA0
(with a slanted outgoing cable
unit)
To make a dual connection
– for the PD and the DP
master on the
PROFIBUS-DP network, for
example – via a DP
interface (see Figure 4-5)
Bus connector with a PD
socket (up to 12 Mbaud)
6ES7 972-0BB10-0XA0
(with a straight outgoing cable
unit)
6ES7 972-0BB40-0XA0
(with a slanted outgoing cable
unit)
To connect the PD to the
bus connector with the PD
socket
PD connecting cable (up to
1.5 Mbaud)
6ES7 901-4BD00-0XA0