Siemens LMV50 series

322/327
Building Technologies Basisdokumentation LMV5... CC1P7550en
23 Index 22.05.2018
Input 2
TEMP./PRESS INPUT, X61 118
Input 3
SETPOINT INPUT X62 120
Input 4
TEMP, Pt1000/LG-Ni1000 X60 119
inputs and outputs 275
inputs for external controller (ON/OFF)
X5-03 46
inputs/outputs 239
Inputs/outputs
Flame signal input / flame detector
X10-02, X10-03 32
Self-test function LMV5/QRI/QRA 32
installation 213
installation notes 14
integrated temperature limiter function
123
internal setpoint 120
Ionization
Technical Data 34
L
Lambda factor 253
Life cycle 19
light oil direct ignition 76
light oil with gas pilot ignition 78
List of phase display
Auxiliary functions 72
LMV5
Cable length AGG5.6 219
Extra functions 181
Installation examples 215
Second AGG5.2 power transformer
223
Types of cable 220
LMV50
Cooling function 70
High temperature supervision 41
LMV50/LMV52
Continuous pilot 69
Flame supervision 33
LMV50/LMV52.4
Long postpurge time 70
LMV52 with FGR 289
LMV52 with O2 trim control and PLL52
251
LMV52.4
settings in deactMinpos or auto
deact mode 300
load limitation with O2 trim control 257
load-dependent activation of the higher
burner stages 115
loads on terminals, cable lengths and
cross-sectional areas 230
loss-of-flame test 165
M
measuring the O2 min values by
lowering the air rate 282
menu structure 139
modulating control 109
monitoring with extra air pressure
switch 240
mounting clip for mounting rail 224
mounting electrical installation and
service 213
mounting notes 12
multiboiler plants 129
multiboiler plants by means of analog
input 129
multiboiler plants by means of digital
interface 129
multistage control 115
N
notes on mounting the AZL5 13
notes on mounting the LMV5 12
Number fuel actuators 85
O
O2 alarm 268
O2 control
Loads on terminals, cable lengths
and cross-sectional areas 288
O2 sensor test 271
O2 trim control 228, 255
Air rate change 252
Burner start mode 258
Deactivation 266
Display 267
Enabling modulation 261
Inactivation / deactivation of O2
alarm 270
Increasing the manipulated variable
262
Limiting the manipulated variable 264
Maintenance timer 274
O2 maximum value alarm 270
O2 minimum value alarm 269
Trim control behavior 263
operating mode 1 101
Operating mode 2 102
operating mode 3 103
operating mode 4 104
operating mode 5 105
operating mode 6 106
operating mode changeover to internal
load controller 107
operating modes load controller 101
operating modes of O2 trim
controller/O2 alarm 255
operating position modulating 96
operating position multistage 96
operation 89
other notes 287
output, modulating 128
output, multistage 128
outside the operating position 96
P
Parameter
Reaction time / safety time 59
Time parameter 59
parameter for the FGR function 291
Parameterizations 285
Parameterizing the type of fuel 279
parameters 59
pin assignment cable connection
Siemens AZL5 - SPI3 132
PLL52 275
port for the PC 134
ports of the AZL5 133
power supply to the LMV5 214
Precontrol 254
preset fuel parameters 280
process data 247