Siemens LOGO!Power Series - Connections and terminal designation

Description, device design, dimension drawing
2.2 Connections and terminal designation
LOGO!Power
10 Operating Instructions, 06.2014, C98130-A7560-A999-3-7629
2.2
Connections and terminal designation
Note
UL requirement:
Use suitable copper cables that are designed for operating temperatures of
at least 65
°C / 75 °C.
The line input terminals ① can be used to establish the connection to supply voltage. The
output terminals
② are used to connect to the loads to be supplied (see also Section
Installation (Page 23)).
Connections and terminal designations
①
line input L1, N
One screw terminal each
②
Output +
Two screw terminals
②
Output –
Two screw terminals
*1)
Do not subject the end stop to higher loads
Figure 2-2 Terminal data