5.4.2 Checking the load handling attachments
Inspect the
load handling attachments such as the load trestles, lifting eyes and ring bolts and
also the lifting gear, before lifting the machine:
● Inspect the load handling attachments on the machine for possible damage. Replace any
load suspension equipment that is found to be damaged.
● Before use, check that the load suspension equipment is correctly attached.
● When lifting the machine, use only approved and undamaged lifting gear of sufficient rated
capacity. Check the lifting gear prior to its use.
WARNING
The machine can be dropped
If the load handling attachments and lifting gear are damaged or not correctly secured,
the machine may be dropped during lifting. This can result in death, serious injury or
material damage. Inspect the load handling attachments and lifting gear before use.
5.4.3 Lifting and transportation
● Persons driving cranes and fork lift trucks must hold appropriate qualifications.
●
When lifting the machine, use only approved and undamaged sling guides and spreaders
of sufficient rated capacity. Check these before using them. The weight of the machine is
stated on the rating plate.
Assembly
5.4 Lift the machine to where it will be installed, and position it
LOHER CHEMSTAR 1PS2
42 Operating Instructions 08/2016
To Next Page
Loading...
