Procedure
1. Lift the machine using two separate beams and crane trolleys ①
.
2. Leave the drive-end beam in place and continue to lift the rotatable non-drive-end beam
until the machine reaches its center of gravity and the drive-end beam is unloaded ②.
3. Remove the drive-end lifting beam. Rotate the machine through 180°. When doing this,
take care not to damage any attached parts.
4. Place the free beam on the lifting eyes provided and lift the machine using this beam until
it is perpendicular to the base ③.
Image 5-1 Erecting the motor
Turning the machine on to its side
To lay the machine on its side, proceed in the reverse order.
5.4.6 Removing anti-corrosion protection
Machined,
bare metal surfaces of machine parts and small components such as screws, bolts,
wedges, feather keys, and dowel pins, are treated with an anti-corrosion agent.
Carefully remove the anti-corrosion agent and immediately start the installation work.
Assembly
5.4 Lift the machine to where it will be installed, and position it
LOHER CHEMSTAR 1PS2
Operating Instructions 08/2016 45
To Next Page
Loading...
