5.4.4 Putting the machine down
Requirements
The following preconditions must be satisfied before setting down the machine at the
installation location:
● The mating faces must be clean.
●
The anti-corrosion protection paint has been removed from the mating faces, such as the
machine mounting feet, flange, ...
● There is no condensation present within the machine.
Setting down the machine
● Set down the machine slowly and carefully at the installation location to avoid any impact.
See also
Removing anti-corrosion protection (Page 45)
Requirement
The transmission element such as a coupling half has already been pulled on.
Roughly aligning the machine
● For horizontal positioning, push the motor sideways across the foundation. When doing so,
ensure that the axial position is maintained.
5.4.5 Turning a machine upright or laying it on its side
Lifting beams must always be used when lifting and the machine or laying it on its side. One
of the beams must be free to rotate.
● Persons driving cranes must hold appropriate qualifications.
● When lifting the machine, use only approved and undamaged lifting beams of sufficient
rated capacity. Check these before using them. The weight of the machine is stated on the
rating plate.
● When setting the machine upright, refer to the information on the lifting plate:
– Comply with the specified spreading angles.
– Lift the machine without jerking it.
Assembly
5.4 Lift the machine to where it will be installed, and position it
LOHER CHEMSTAR 1PS2
44 Operating Instructions 08/2016
To Next Page
Loading...
