Siemens MPP 464 IE H User Manual

Note
When using LEDs, make sure that they are connected with the correct polarity, see 󹪝gure:
"Mounting position LEDs MPP 464 IE H".
Mounting additional operator controls
According to the speci󹪝cations of the respective manufacturer.
Inserting the slide-in labels
Note
Slide in the labels when the MPP is not yet installed.
1. Create the slide-in labels.
See chapter "Accessories and spare parts" > "Labelling the slide-in labels".
2. Pull the protective 󹪝lms o󹪜 the slide-in slot.
3. Insert the slide-in label. The inscription must face the operator side.
4. Align the texts in the window.
Replacing the contact makers S01-S04, S07-S10
1. Loosen the screw cap on the pushbutton to just before the contact maker.
2. Pull the pushbutton and contact maker approx. 3 mm out of the socket (the latch of the
pushbutton must be released).
3. Remove the LED.
4. Replace the contact element, remove the defective contact maker from the socket, and press
the new contact maker onto the socket.
5. Insert the pushbutton into the aperture and partially screw on the screw cap.
6. Press the pushbutton onto the contact maker until it latches. Note the position of the latch.
7. Tighten the screw cap according to the torque speci󹪝ed by the manufacturer.
Mounting
Machine Pushbutton Panel: MPP 464 IE H
44 Equipment Manual, 03/2021, A5E50810237B AA

Siemens MPP 464 IE H Specifications

General

Brand	Siemens
Model	MPP 464 IE H
Category	Industrial Equipment
Language	English