Siemens MPP 464 IE H - Assembled PCB Connection Board

Switch S1
For settings, see the manual "Machine Control Panel: MCP 310C PN", chapter "Interfaces".
Switch S2
For settings, see the manual "Machine Control Panel: MCP 310C PN", section "Interfaces", mode
"MCP set up as IE".
3.4.2.3 Assembled PCB connection board
Power supply interface X1
Connector designation: X1
Connector type: Terminal block, 3-pin male connector
Cable length (max.): 10 m
Table 3-10 Interface power supply
Pin Signal name Type Meaning
1 2P24 V 24 V potential
2 M24 24 V ground
3 PE Shield potential
Plug X20 / X21
Connector designation: X20 / X21
Connector type: Mini-Combicon MC 1.5/4-G-3.81
Cable length (max.): 30 m
Table 3-11 Plug X20 / X21
Plug Pin Signal Type Signal name Function
X20 1 OE_S2
I/O
NC contact S2
2 OE_S1 NC contact S1
X21 1 OE_S4
I/O
NC contact S4
2 OE_S3 NC contact S3
X20 3 BZOE_S1-4 I/O Reference pot. NC contact S1 ... S4
4 BZS_S1-S6 Reference pot. NO contact S1 … S6
Description
3.4 Interfaces
Machine Pushbutton Panel: MPP 464 IE H
26 Equipment Manual, 03/2021, A5E50810237B AA