Siemens OpenStage 20 E - Page 53

Enhanced phone functions
53
Step by Step
Beep on auto-reconnect
When active, this option lets you resume a held call
with either the CTI application or phone. A beep sounds
when you toggle between an active call and a held call
when the function is active.
Prerequisite: The option was programmed by your ad-
ministrator.
z
You can also configure this setting via the Web interface
Æ page 101.
N Press the key shown.
Select and confirm the option shown.
if nec.
j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select the option shown and confirm twice.
User
Configuration
Incoming calls?
CTI calls? f
Auto-reconnect = No f
Yes l
Beep on auto-unhold = No f
Yes l
Option = Save & Exit l