Siemens OpenStage 20 E - Using Autodial Delay

Enhanced phone functions
55
Step by Step
Using autodial delay
A number is automatically dialed after a set delay start-
ing from the entry of the number’s last digit. The auto-
dial delay can be used:
• when dialing in idle mode
• when setting up a consultation call
• when transferring an answered call.
The delay can be reduced by performing one of the fol-
lowing activities:
i • pressing the i key. This always works.
^ • lifting the handset. This only works if the phone num-
ber was entered when the phone was idle or if it was
entered for a consultation call when the handset was
off hook.
n • pressing the loudspeaker key (OpenStage 20/20 G
only). This only works if the phone number was en-
tered when the phone was idle and the loudspeaker
key was not lit or if the phone number was entered
for a consultation call and the loudspeaker key was
not lit.
If an emergency number is preset by your admin-
istrator, the autodial delay for this phone number
is reduced to one second.