Siemens OpenStage 20 E - Marking the Last Line in the Hunt Group Chain

Step by Step
HiPath 8000 functions
86
Marking the last line in the hunt group chain
Sets the "stop hunt" line in the hunt group chain. The
system will stop looking for a free line in the hunt group
chain after it reaches this line.
Activating
^ Lift the handset.
j Enter the access code (see access code table
Æ page 87).
Z Wait until you hear the confirmation tone.
Deactivating
Unmark the line as the end of the hunt group chain.
^ Lift the handset.
j Reenter the access code (see access code table
Æ page 87).
Z Wait until you hear the confirmation tone.