The Keypad and Display Interface Perfect Harmony GENIII/e User’s Manual
3-64 A1A19000405A: Version 1.3
3
Table 3-61: Hour Meter Setup (8010)
IAIN Phase A input current (A) SMFC Synch Motor Field Current (A)
BIN Phase B input current (A) %ESP Encoder Speed (%)
ICIN Phase C input current (A) ERPM Encoder Speed (RPM)
IAVI Total input current (A)
Parameter ID Units Default Min Max Description
Display hour meter 8020 Function
Used to display the amount of time that
the drive has been operational since it was
commissioned.
Preset hour meter 8030 Function
Used to preset the hour meter to the accu-
mulated time that the drive has been
operational since it was commissioned (in
the event that a micro board has been
replaced on an existing drive).
Reset hour meter 8040 Function
Used to reset the hour meter when the
drive is commissioned.
Display Output kWH
meter
8050 Function
Displays the total output kW hours that
have been accumulated since the drive
was commissioned.
Preset output kWH
meter
8060 Function
Presets the output kW hour counter to a
previous value (when the microboard is
replaced).
Reset output kWH
meter
8070 Function
Resets the output kW hour counter to
zero.
Display input kWH
meter
8072 Function
Displays the total input kW hours that
have been accumulated since the drive
was commissioned.
Preset input kWH
meter
8074 Function
Presets the input kW hour counter to a
previous value (when the microboard is
replaced).
Reset input kWH
meter
8076 Function Resets the input kW hour counter to zero.
Abbreviation Description & Units Abbreviation Description & Units
To Next Page
Loading...
