The Keypad and Display Interface Perfect Harmony GENIII/e User’s Manual
3-12 A1A19000405A: Version 1.3
3
Table 3-3: Summary of Common Arrow Key Sequences
3.2.9 Diagnostic Indicators
The standard keypad and display interface also contains 3 diagnostic LED indicators that are located above the
display: Power On, Fault, and Run. The Power On indicator is lit when control power is supplied to the system. The
Run indicator is illuminated when the drive is running. The Fault indicator is lit when one or more system errors have
occurred (e.g., boot-up test failure, overvoltage fault, etc.). The Fault indicator blinks when one or more alarms are
active or unacknowledged. The [FAULT RESET] key must be pressed to clear any existing fault conditions and
restore the system to normal operation. Refer to Figure
3-1 for the location of the 3 diagnostic indicators.
Key Combination Description
Used individually to navigate through the menu structure. Also
used to change the active digit of parameter value (when in edit
mode).
Used individually to scroll through lists of menu options, lists and
parameters. Used to change velocity demand (from default meter
display). Increments/decrements parameter values (when in edit
mode).
Enters “numerical item access mode”. The operator is then
prompted to enter the 1 or 4 digit ID number for the associated
item.
Jumps to the top menu of the currently selected menu or submenu.
Hitting an additional up arrow will take you out of the current
menu or submenu to the previous menu.
Restores the security level back to 0. The [SHIFT]+[A] (left
arrow) key sequence must be entered three times in succession
from the default meter display to restore the security level back to
0.
Jumps to the bottom menu item of the currently selected menu of
submenu.
When editing a value that has been changed from its factory
default, this key sequence will return the value to its factory
default.
To Next Page
Loading...
