Siemens PERFECT HARMONY GENIII/E Series - The Display

Perfect Harmony GENIII/e User’s Manual The Keypad and Display Interface
A1A19000405A: Version 1.3 3-13
s
s
ss
3
3.2.10 The Display
After power up or reset, the Siemens identification and software version number is displayed for 2-3 seconds.
Afterward, the meter display is shown on the LCD by default. The meter display is the starting point of the menuing
system. This display remains on the LCD until keys are pressed.
Figure 3-8: The Identification/Version Screen and Meter Displays
The meter display screen contains five fields that are monitored and updated dynamically. These fields are the MODE
(the operational mode), DEMD (the velocity demand), RPM (calculated revolutions per minute), VLTS (motor
voltage), and ITOT (total output current) fields. The value (or state) of each field is shown dynamically on the second
line of the display. Refer to Figure
3-9. The MODE field is fixed. The last 4 fields on the display contain parameter
values that can be defined by the operator.
Figure 3-9: Dynamic Programmable Meter Display
The MODE field displays the current operational mode of the Harmony system. This field can have any one of the
displays summarized in Table
3-4, depending on the current operation mode or the current state of the drive.
Figure 3-10: Dynamic Programmable Meter Display in Rollback Mode
Figure 3-11: Dynamic Programmable Meter Display in Regeneration Mode
MODE DEMD FREQ RPM ITOT
HAND 70 70 1260 40
ASIRobicon Harmony
VERSION #.## Date
MODE DEMD RPM VLTS ITOT
KYPD 80 1440 3328 50
Top row of display shows field
name. MODE is displayed when
not in RGEN or RLBK mode.
Bottom row of display
shows dynamic values
Fixed display field
User-defined display
fields
RLBK DEMD RPM VLTS ITOT
KYPD 80 1440 3328 50
Top row of display shows RLBK
for rollback mode . KYPD in row
2 indicates manual mode also .
Bottom row of display
shows dynamic values
Fixed display field
User-defined display
fields
RGEN DEMD RPM VLTS ITOT
KYPD 80 1440 3328 50
Top row of display shows RGEN
for regen mode . KYPD in row 2
indicates manual mode also .
Bottom row of display
shows dynamic values
Fixed display field
User-defined display
fields