Siemens PERFECT HARMONY GENIII/E Series - Meter Menu (8) Options

Perfect Harmony GENIII/e User’s Manual The Keypad and Display Interface
A1A19000405A: Version 1.3 3-61
s
s
ss
3
Table 3-57: Single Phasing Menu (7010)
3.3.8 Meter Menu (8) Options
The Meter Menu (8) consists of the following menu options:
• Display Parameters Menu (8000)
• Hour Meter Setup Menu (8010)
• General Drive Parameters Menu (Set Time, Software Version, Language, Output Units)
• Input Harmonics Menu (8140)
These menus are explained in tables that follow.
Table 3-58: Meter (8) General Drive Parameters
Parameter ID Units Default Min Max Description
SPD prop gain 7020 0.0 0.0 10.0
Single phase detector PI regulator
proportional gain term.
SPD integral gain 7030 0.001 0.0 1.0
Single phase detector PI regulator integral
gain term.
SPD threshold 7040 % 50.0 0.0 100.0
Regulator output level below which an
alarm is generated
Parameter ID Units Default Min Max Description
Display Parameters 8000 Submenu
This menu contains display
parameters. See Table 3-59.
Hour Meter Setup 8010 Submenu
This menu contains hour meter
setup. See Table
3-61.
Input Harmonics 8140 Submenu
This menu contains input harmonics.
See Table
3-62.
Fault Display
Override
8200 Off
Enables or disables the display of
Fault/Alarm messages on the
keypad.
Set the clock time 8080 Function
Used to change the time and date of
the real-time clock chip.
Display version
number
8090 Function
Displays the installed version of
firmware.
Customer order 8100 0 0 9999999 Customer order number
Customer drive 8110 1 0 20 Customer drive number