Perfect Harmony GENIII/e User’s Manual The Keypad and Display Interface
A1A19000405A: Version 1.3 3-17
3
Table 3-5: Summary of Operation Mode Displays: Line 2 of Mode Display
Code Meaning Description
NOMV No medium voltage No input line voltage detected.
INH CR3 inhibit The CR3 or “Drive inhibit” input is asserted.
OFF Idle state The drive is ready to run but is in an idle state.
MAGN Magnetizing motor state The drive is magnetizing the motor.
SPIN Spinning load state
The drive is trying to detect the speed of the motor to synchronize
the drive frequency.
UXFR Up transfer state
The drive is in the “Up Transfer State” preparing to transfer the
motor to the input line.
DXFR Down transfer state
The drive is in the “Down Transfer State” preparing to transfer the
motor from the input line to the drive.
KYPD Keypad speed demand The drive speed demand source is the keypad.
TEST Speed/Torque test The drive is in a Speed or Torque test mode.
LOS Loss of Signal
The drive 4-20mA analog input signal has dropped below a
predefined setting. See Tables 3-34, 3-35, 3-37, and 3-38.
AUTO Automatic mode
The SOP flag AutoDisplayMode_O is set true usually to indicate
drive is receiving its speed demand from a source other than the
keypad or network. Typically used with a analog input speed
source.
NET1 Network 1 Indicates drive is being controlled from Network 1.
NET2 Network 2 Indicates drive is being controlled from Network 2.
DECL Decelerating (no braking) The drive is decelerating normally.
BRAK Dynamic Braking Indicates that dynamic braking is enabled.
COAS Coasting to stop
The drive is not controlling the motor and it is coasting to a stop
due only to friction.
TUNE Auto-Tuning
The drive is in a “Auto-Tuning” mode used to determine motor
characteristics.
HAND Hand mode Appears if the drive is running under normal conditions.
To Next Page
Loading...
