Preface
ET 200S Distributed I/O System - Fail-Safe Modules
6 Installation and Operating Manual, 08/2008, A5E00103686-07
Conventions
In this manual, the terms "safety engineering" and "fail-safe engineering" are used
synonymously. The same applies to the terms "fail-safe" and "F-."
"
S7 Distributed Safety
" and "
S7 F Systems
" in italics refer to the optional packages for the
two F-systems: "S7 Distributed Safety" and "S7 F/FH Systems".
Recycling and Disposal
Due to the low levels of pollutants in the fail-safe modules of the ET 200S, the modules can
be recycled. For proper recycling and disposal of your old module (device), consult a
certified disposal facility for electronic scrap.
Additional Support
If you have any further questions about the use of products described in this manual, and do
not find the right answers there, contact your local Siemens representative
(http://www.siemens.com/automation/partner
).
Training center
We offer courses to help you get started with the S7 automation system. Contact your
regional training center or the central training center in Nuremberg (90327), Federal Republic
of Germany.
Telephone: +49 911 895-3200
On the Internet (
http://www.sitrain.com)
H/F Competence Center
The H/F Competence Center in Nuremberg offers special workshops on SIMATIC S7 fail-
safe and redundant automation systems. The H/F Competence Center can also provide
assistance with onsite configuration, commissioning and troubleshooting.
Telephone: +49 911 895-4759
Fax: +49 911 895-5193
hf-cc.aud@siemens.com
For questions about workshops / training: hf-training.industry@siemens.com
Technical Support
You can contact Technical Support for all IA products as follows:
● By completing a Support Request (http://www.siemens.de/automation/support-request
)
on the Internet
● Telephone: +49 180 5050 222
● Fax: +49 180 5050 223
For additional information about Siemens Technical Support, refer to Internet
(http://www.siemens.de/automation/service
).
To Next Page
Loading...
Need help?
General
