Siemens POLYCOOL RWR470.10 - 4 General Device Settings; Modes of Operation; Accessing the Menus

4 General Device Settings
Modes of Operation
The current RWR470.10 controller consists of three kinds of operation modes:
Mode Function
1 Normal working mode Display all running devices and measured values
2 Menu mode* View configured analog inputs, warning and alarm logs
Set/adjust parameter values and also user privilege to
parameters
3 Stop mode** Normally shut-down status (all units stop running.)
*To enter menu mode, see also <Chapter 4.2. Accessing the Menus>.
• In normal working mode, the back light will be timed out after 30seconds without any
operation.
Accessing the Menus
Display Procedures
.
+
-
In Stop mode, press the <Enter> button
for 2 seconds and release it to enter the
Menu mode.
By default, the Query icon is blinking,
waiting for further instructions.
To view the latest 10 warnings generated:
• Navigate to the
!
menu by pressing <Plus> or <Minus>, and then press <Enter> to
confirm and proceed.
To view the latest 20 alarms generated:
• Navigate to the menu by pressing <Plus> or <Minus>, and then press <Enter>
to confirm and proceed.
To set parameter values:
• Navigate to the menu by pressing <Plus> or <Minus>, and then press <Enter> to
confirm and proceed. Contents under this menu may vary with the privilege right of
the user.
− For end users, select “NO,” and press <Enter > to proceed.
− For service men and factory users, select “EU” or”ID”and press <Enter> to input
the password.
9/28
Siemens Building Technologies SIEMENS Controller HEAT PUMP controller
HVAC Products 27.11.2006
Notes