5 Fast Configuration via PolyStick
Only trained staff can perform fast configuration via PolyStick.
Downloading Application and Parameters from
PolyStick
To download application and parameters from PolyStick to the controller, follow steps
below:
• Power off the controller
• Plug PolyStick into RJ45 service interface
• Re-apply power to the controller
• Wait while the green LED is continuously blinking, indicating the data communication
process
• Once finished, the controller will be set in Stop mode, and the green LED fixed
• Un-plug the PolyStick
• Press <Esc> to activate the system from Stop mode
6 Customizing Application by Adjusting
Parameter Values
Accessing the Parameter Menu
Display Procedures
In Stop mode, press <Enter> for 2 seconds and release it to activate the Menu mode.
When the
icon is blinking, press <Plus> or <Minus> to navigate to
the
men
u,
and then press <Enter> to proceed.
Contents under the menu may vary with the privilege right of the user.
• For end users, select “NO” and press <Enter > to proceed.
• For service men and factory users, select “EU” or “ID”and press <Enter>. Input the
4-digit password when the following screen is displayed
To Next Page
Loading...
