10 / 46
Siemens Wall-mounted sensors and room operator units for KNX/ETS and KNX/ACS CM2N1602en_05
Building Technologies Devices 2018-09-14
1.6 Environmental compatibility, disposal
1.6.1 General notes
This device was developed and manufactured with environmentally compatible
materials and procedures complying with all relevant environmental standards.
Note the following to dispose of the product following its useful life or in case of
replacement:
• Do not dispose of the device as part of standard household garbage, but as
special waste from plastic and steel, ferrite-magnet components.
This applies in particular to the PCB.
• For this reason, dispose of the components compatible with current
environmental, recycling, and disposal technologies.
Observe all local, applicable laws.
• The aim is to reuse as much of the basic materials as possible at the lowest
possible environmental impact. To this end, note any material and disposal
notes in individual components.
1.6.2 Environmental declaration
The product environmental declaration CM2E1602 contains data on
environmentally compatible product design and assessments (RoHS compliance,
materials composition, packaging, environmental benefit, disposal)
1.6.3 Notes on FCC rules
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2)
t
his device must accept any interference received, including interference that
may cause undesired operation.
To Next Page
Loading...
