5 / 46
Siemens Wall-mounted sensors and room operator units for KNX/ETS and KNX/ACS CM2N1602en_05
Building Technologies About this document 2018-09-14
Before using our products, it is important that you read the documents supplied
with or ordered at the same time as the products (equipment, applications, tools
etc.) carefully and in full.
We assume that persons using our products and documents are authorized and
trained appropriately and have the technical knowledge required to use our
products as intended.
For more details on the products and applications, please refer to:
• On the internet: "Technical product data and descriptions" at
www.siemens.com/gamma-td
• On the intranet (for Siemens employees only) at
http://step.bt.siemens.com/portal/index.html
• At your next Siemens branch office www.siemens.com/sbt or at your system
suppliers.
• From the support team in the headquarters fieldsupport-
zug.ch.sbt@siemens.com if no local POC is available.
Siemens assumes no liability to the extent allowed under the law for any losses
resulting from a failure to comply with the aforementioned points or for the
improper compliance of the same.
0.3 Abbreviations and naming conventions
Engineering Tool for Synco devices
Engineering Tool Software http://www.knx.org/
Communication with KNX, configuration with ACS
Communication with KNX, configuration with ETS
T
he term "room operator unit" in this document always refers to all types:
QMX3.P02. P30. P34, P70 und P74.
0.4 Reference documents
The following documents are available at www.siemens.com/gamma-td
[1] Data sheet N1602
[2] Mounting instructions M1692
[3] Word template for labels (QMX3.P02, P37) M1602.1
[4] KNX Standard, Volume 3: System Specifications, Part 7, Chapter 2: Data
P
oint Types (http://www.knx.org/
)
[5] Service- and Operating software ACS790 (Data sheet N5649)
Use of documents /
Request to the reader
To Next Page
Loading...
