4 / 46
Siemens Wall-mounted sensors and room operator units for KNX/ETS and KNX/ACS CM2N1602en_05
Building Technologies About this document 2018-09-14
0 About this document
0.1 Revision history
_05 2018-09-14 • Corrections/additions for V6.1
All
—
_04 2017-03-10 • Corrections/additions for V6.1
• Added QMX3.P40
All —
• Corrections/additions for V6.0
_02 2015-04 • Corrections for V5.1
5.3 —
0.2 Before you start
The trademarks used in this document and their lawful owners are listed in the
table below.. The use of trademarks is subject to international and domestic
provisions of the law.
KNX Association, B - 1831 Brussels-Diegem Belgium
http://www.knx.org/
All product names listed in the table are registered (®) or not registered (™)
trademarks of the owner listed in the table. These trademarks will not be indicated
elsewhere in the text (e.g. by use of symbols such as ® and ™) due to the
reference in this Section and to facilitate the reading of the text,
This
document may be duplicated and distributed only with the express permission
of Siemens, and may be passed only to authorized persons or companies with the
required technical knowledge.
These documents were prepared with great care.
• The contents of all documents are checked at regular intervals.
• All necessary corrections are included in subsequent versions.
• Documents are automatically amended as a consequence of modifications and
corrections to the products described.
Please make sure that you are aware of the latest document revision date.
If you find any lack of clarity while using this document, or if you have any
criticisms or suggestions, please contact your local POC at the nearest branch
office. Addresses for Siemens RCs are available at www.siemens.com/sbt
To Next Page
Loading...
