Siemens QMX3.P30 - ACS Parameter Description; Communication; Universal Temperature Sensor; Room Humidity Sensor

46 / 46
Siemens Wall-mounted sensors and room operator units for KNX/ETS and KNX/ACS CM2N1602en_05
Building Technologies ACS engineering 2018-09-14
6.3 ACS Parameter description
Factory settings are boldfaced.
6.3.1 Communication
Designation
Values
Description
Geographical zone (apartment)
---, 1...126
Geographical zone, apartment or room group
Geographical zone (room)
---, 1…63
Geographical zone, room
Geographical zone (subzone)
---, 1…15
Geographical zone, subzone
6.3.2 Universal temperature sensor
Designation
Values
Description
LTE transmission zone
---, 1…4095
Sending zone for KNX/ACS
Sensor correction
-5...+5K
in 0.1K steps
0K
Correction of universal temperature sensor value
6.3.3 Room humidity sensor
Designation
Values
Description
LTE transmission zone
---, 1…4095
Sending zone for KNX/ACS
6.3.4 Room air quality sensor
Designation
Values
Description
LTE transmission zone
---, 1…4095
Sending zone for KNX/ACS
Altitude above sea level [m]
0…3000 m
0 m
Entry of altitude above sea level at measuring location to correct CO
2
measured
value
Distributed by:
Siemens Switzerland Ltd.
Building Technologies Division
International Headquarters
Gubelstrasse 22
6301 Zug
Switzerland
Tel. +41 41
-724 24 24
www.siemens.com/buildingtechnologies
© Siemens Switzerland Ltd, 2013
Delivery and technical specifications subject to change