5.3.2 Read live data via PCT Go
After installation, commissioning and power-on, installers can load the working
data for the thermostat to the PCT Go via NFC, by selecting "Read live data".
The information allows the installer to verify if the device operates in expected
conditions and correctly wired.
The following data can be read via PCT Go:
● Data menu:
− Sensor measurement and correction
− Working conditions (H/C demand, H/C sequence, operating mode)
− Application information
− Input / output information
− KNX related settings
● Device menu:
− Device information
The live data can be saved and a project report (PDF file) generated.
For the application with 6-port PICV, live data displays the selected limitation and
measurement of the waterflow in liters per hours.
To Next Page
Loading...
