5.2 ACS tool
The ACS tool is used to commission the RDG2..KN KNX room thermostats
(physical address, application, parameters). They can be operated or monitored by
bus during normal operation.
This section does not describe how to define the physical address and only
provides a brief overview of ACS main function.
For more information, refer to the ACS online help.
Setting RDG2..KN KNX parameters is only supported by ACS version 13.03 or
higher.
5.2.1 Setting parameters in ACS
In the ACS program, select Plant ➙ Open to open the plant.
To open the parameter settings, select Applications ➙ Plant engineering.
The application and control parameters can be adjusted and downloaded.
Line no. contains the parameter number as displayed in the parameter table. See
Control parameters [➙ 138].
To Next Page
Loading...
