Siemens RUGGEDCOM RMC30 - Resetting the Device

RUGGEDCOM RMC30
Installation Guide
Chapter 2
Installing the Device
Resetting the Device 11
Communication Ports
Connect the copper Ethernet port to a management switch and access the RUGGEDCOM ROS console and
Web interfaces via the device's IP address. The factory default IP address for the RUGGEDCOM RMC30 is
https://192.168.0.1 .
For more information about available ports, refer to Chapter3, Communication Ports .
Section2.4
Resetting the Device
The RUGGEDCOM RMC30 can be reset (rebooted) using the RESET button. The RESET button is recessed and can
only be reached using a pin or small screwdriver.
To reset the device, quickly press and release the RESET button with a pin.