Siemens RUGGEDCOM RX5000 - Other Approvals; EMC and Environmental Type Tests

Chapter 6
Certification
RUGGEDCOM RX5000
Installation Guide
34 Other Approvals
• China RoHS 2
Administrative Measure on the Control of Pollution Caused by Electronic Information Products
A copy of the Material Declaration is available online at https://support.industry.siemens.com/cs/ww/en/
view/109738831.
Section6.1.9
Other Approvals
This device meets the requirements of the following additional standards:
• IEEE 1613
IEEE Standard Environmental and Testing Requirements for Communications Networking Devices in Electric
Power Substations
• IEC 61850-3
Communications Networks and Systems for Power Utility Automation – Part 3: General Requirements
• IEC 61000-6-2
Electromagnetic Compatibility (EMC) – Part 6-2: Generic Standards – Immunity for Industrial Environments
Section6.2
EMC and Environmental Type Tests
The RUGGEDCOM RX5000 has passed the following EMC and environmental tests.
IEC 61850-3 EMC Type Tests
Test Description Test Levels
Severity
Levels
Enclosure Contact +/- 8 kV 4
IEC 61000-4-2 ESD
Enclosure Air +/- 15 kV 4
IEC 61000-4-3 Radiated RFI Enclosure Ports 20 V/m Note
a
Signal ports +/- 4 kV @ 2.5 kHz Note
a
DC Power ports +/- 4 kV 4
AC Power ports +/- 4 kV 4
IEC 61000-4-4 Burst (Fast Transient)
Earth ground ports +/- 4 kV 4
Signal ports
+/- 4 kV line-to-earth,
+/- 2 kV line-to-line
4
DC Power ports
+/- 2 kV line-to-earth,
+/- 1 kV line-to-line
3
IEC 61000-4-5 Surge
AC Power ports
+/- 4 kV line-to-earth,
+/- 2 kV line-to-line
4
Signal ports 10 V 3
IEC 61000-4-6 Induced (Conducted) RFI
D.C Power ports 10V 3