20/166
Siemens Building Technologies Basic Documentation RVA47.320 CE1P2379E
HVAC Products Handling 15.07.2002
2.4 Parameter settings for the enduser
The following settings can be made to meet the individual needs of the enduser.
Buttons Explanation Line
1
Press one of the line selection buttons.
This will take you directly to the programming level
"Enduser”.
2
Press the line selection buttons to select the required
line.
The parameter list on the next pages contains all
available lines.
• • •
3
Press the + or - button to set the required value.
The setting will be stored as soon as you leave the
programming mode or change to another line.
The parameter list on the next 2 pages contains all
settings that can be made.
4
By pressing any of the operating mode buttons, you
leave the programming level "Enduser”.
Note:
If no button is pressed for about 8 minutes, the
controller will automatically return to the operating
mode selected last.
Contin.
display
Description
Setting
To Next Page
Loading...
