Siemens RVA47.320 - End-User Settings Configuration; Heating Circuit Operating Modes

32/166
Siemens Building Technologies Basic Documentation RVA47.320 CE1P2379E
HVAC Products Description of the enduser settings 15.07.2002
3 Description of the enduser settings
User interface
3.1 Heating circuit operating modes
• Straightforward selection of heating circuit operating modes
The control provides 3 different heating circuit operating modes that can be directly
selected as required.
Select the required operating mode by pressing the respective operating mode button.
It is located on the controller front for direct access by the user.
Operating
mode
Designation Effect of selected operating mode
Automatic
operation
• Heating according to the time program
(operating lines 5 to 11)
• Temperature setpoints according to the heating
program
• Protective functions active
• Changeover on the room unit active
• Automatic summer / winter changeover and
automatic 24-hour heating limit active (ECO
functions)
continuous
operation
• Heating mode with no time program
• Temperature adjustment with the setpoint knob
• Protective functions active
• Changeover on room unit inactive
• Automatic summer / winter changeover and
automatic 24-hour heating limit inactive (ECO
functions)
Standby
• Heating OFF
• Temperature according to frost protection
• Protective functions active
• Changeover on room unit inactive
Benefit
Description
Setting