Siemens SCALANCE XP-200 - SELECT; SET Button

Description of the device
2.5 SELECT / SET button
SCALANCE XP-200
Operating Instructions, 05/2016, C79000-G8976-C428-01
35
2.5
SELECT / SET button
NOTICE
Loss of water and dust protection
If the film of the button is damaged, the device is not water and dust proof.
Make sure that the film of the button does not get damaged. Do not use e.g. sharp objects
to press the button.
Position
The "SELECT/SET" button is located on the front of the SCALANCE XP-200.
Figure 2-2 SELECT/SET button
Setting the display mode
To set the required display mode, press the "SELECT/SET" button.
For more detailed information on the display modes, refer to the section "LEDs "DM1" and
"DM2" (Page 29)".