In the configuration discussed here, 3 different VLANs are configured: A TIA
interface (VLAN 1) that serves as a configuration interface and 2 VLANs for the
server (VLAN 10) and the cell (VLAN 20). The communication between the virtual
networks is done via routing. A port-based VLAN is used in this setup for VLAN
division. The telegrams to the cell and to the servers are sent without a tag, as
there are no devices there that can interpret it.
General settings
1. Open the menu "Layer 2 > VLAN".
2. Enter the VLAN ID 10 and 20.
3. "Create" the VLANs 10 and 20.
4. Assign the VLANs a name.
5. Click the "Set Values" button.
Port assignment
1. Open the "Port Assignment" tab.
2. Set "Port P1.3" to "U" (untagged) for VLAN 10.
3. Set "Port P1.4" to "U" (untagged) for VLAN 20. The packets will be sent without
a tag. These settings apply only to outgoing telegrams.
4. Click the "Set Values" button.
To Next Page
Loading...
Need help?
General