Siemens SCALANCE XR-500 User Manual

Note
Installation with four-point mounting
Where mechanical strain is liable to be high, for example when used on a ship, four-point
mounting is necessary.
You will 󹪝nd details in the sections "Four-point mounting (Page55)" and "Mechanical stability
(in operation) (Page115)".
Mounting
CAUTION
Risk of injury if subjected to irregular mechanical strain
The device must be mounted in the 19" rack so that even if there is irregular mechanical strain,
no dangerous situation can result.
Figure5-2 19" rack mounting
To install the device in a 19" rack, follow the steps below:
1. Position the device at the required location in the 19" rack.
2. Screw the two brackets to the 19" rack in each case with 2 securing screws.
3. Connect the cables, see section "Connecting up (Page61)".
Uninstalling
To remove the device from a 19" rack, follow the steps below:
1. Disconnect all connected cables.
2. Undo the securing screws on the mounting brackets
3. Remove the device from the 19" rack.
Installing and removing
5.319" rack mounting
SCALANCE XR-500
54 Operating Instructions, 07/2023, C79000-G8976-C692-01

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English