Siemens Sensformer IPS-601-20WGI - Applied Standards and Norms

Manual for installation of the Sensformer® Connectivity Device
© 2020 Siemens Energy Page 45
11. Overview to applied
standards and norms
Below listing gives an overview on standards and norms which
have been applied during the comprehensive testing phase in the
development process of Sensformer Connectivity Device.
List:
- EN 61000-6-4:2007+A1:2011: Radiated RF emission
measurement
- EN 61000-6-4:2007+A1:2011: Disturbance voltage
measurement on the mains and LAN lines
- EN 61000-6-2:2005: Immunity test against radiated RF
disturbances
- EN 61000-6-2:2005: Immunity test against conducted RF
disturbances on the AC, LAN and signal lines
- EN 61000-6-2:2005: Immunity test against EFT on the AC,
LAN and signal lines
- EN 61000-6-2:2005: Immunity test against SURGE voltages
on the AC lines
- EN 61000-6-2:2005: Immunity test against voltage DIPs
- EN 61000-6-2:2005: Immunity test against short voltage
interruptions
- EN 61000-6-2:2005: Immunity against electrostatic
discharges (ESD)
- MSZ EN 55032:2015: Radiated emission test
- MSZ EN 55032:2015: Conducted emission test
- MSZ EN 61000-4-2:2009: Electrostatic discharge test
- MSZ EN 61000-4-3:2010: Radiated electromagnetic field
immunity test
- MSZ EN 61000-4-4:2013: Electrical fast transient immunity
test
- MSZ EN 61000-4-5:2014: Surge immunity test
- MSZ EN 61000-4-6:2014: Testing the immunity to conducted
disturbances, induced by radio-frequency fields
- MSZ EN 61000-4-8:2010: Power frequency magnetic field
immunity test
- MSZ EN 61000-4-10:2017: Damped oscillatory magnetic field
immunity test
- MSZ EN 61000-4-11:2018 and MSZ EN 61000-4-29:2002:
Voltage dips test
- MSZ EN 61000-4-16:2007: Conducted common mode
disturbances
- MSZ EN 61000-4-18:2007: 1 MHz and 100 kHz Damped
oscillatory wave immunity test