EasyManua.ls Logo

Siemens SIMATIC INOX Series - Technical Specifications

Siemens SIMATIC INOX Series
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Technical specifications
5.3 Technical specifications
Comfort Panels INOX, ITC INOX
Compact Operating Instructions, 09/2017, A5E33472156-AI
35
5.3
Technical specifications
Weight
Device
Weight including clamping frame, gasket and mounting
clips, without packaging
TP700 Comfort INOX
approx. 1.9 kg
TP900 Comfort INOX approx. 2.5 kg
TP1200 Comfort INOX
approx. 3.6 kg
TP1500 Comfort INOX approx. 6.6 kg
TP1900 Comfort INOX, ITC1900 INOX
approx. 8.8 kg
Material
Component
Material
Front frame
Stainless steel, material number 1.4301, V2A
Front membrane
Polyester-based
Mounting gasket
EPDM, 70 Shore A, black
Protection class and degree of protection
Characteristic
Standard
Classification
Protection class
EN 61131-2
Protection class III
Degree of protection, on
the front, for operation at
normal atmospheric
conditions
EN 60529:1991 + A1:2000
and
DIN 40050-9
IP66K
Degree of protection, on
the front, for operation in
hazardous areas of
Zones 2 and 22
See section "Certificates
and approvals (Page 26)",
"ATEX/IECEx approval"
paragraph.
TP700 Comfort INOX, TP1200 Comfort
INOX:
IP66K
TP900 Comfort INOX, TP1500 Comfort
INOX,
TP1900 Comfort INOX, ITC1900 INOX: IP65
Degree of protection,
rear
EN 60529 IP20
Enclosure Type, Front
face only
UL50 TP700 Comfort INOX, TP1200 Comfort
INOX,
TP1900 Comfort INOX, ITC1900 INOX:
Type 4X (indoor use only)
TP900 Comfort INOX, TP1500 Comfort
INOX,
Type 4X/Type 12 (indoor use only)
Note that the information on "enclosure type" is only guaranteed if the mounting cutout
conforms to the following:
The device has been installed according to the information provided in this document.
Material thickness at the mounting cutout:
TP700/900/1200 Comfort INOX: 1.5 ... 6 mm
TP1500/1900 Comfort INOX and ITC1900 INOX 1.5 ... 5 mm
Permitted deviation from plane at the mounting cutout: 0.5 mm
This condition must be fulfilled even for the mounted device.
Permitted surface roughness in the area of the mounting gasket: 120 µm, corresponds
to Rz 120

Related product manuals