Siemens SIMATIC MICRO-DRIVE PDC600 - Page 11

Application examples
The application examples support you with various tools and examples for solving your
automation tasks. Solutions are shown in interplay with multiple components in the system -
separated from the focus on individual products.
You will 󹪝nd the application examples on the Internet (
https://
support.industry.siemens.com/sc/ww/en/sc/2054).
TIA Selection Tool
With the TIA Selection Tool, you can select, con󹪝gure and order devices for Totally Integrated
Automation (TIA).
This tool is the successor of the SIMATIC Selection Tool and combines the known con󹪝gurators
for automation technology into one tool.
An integral component of the TIA Selection Tool is the calculation tool for the design and
component selection of the SIMATIC MICRO-DRIVE drive system.
With the TIA Selection Tool, you can generate a complete order list from your product
selection or product con󹪝guration.
You can 󹪝nd the TIA Selection Tool on the Internet (https://www.siemens.com/global/en/
products/automation/topic-areas/tia/tia-selection-tool.html).
SIMATIC Automation Tool
You can use the SIMATIC Automation Tool to perform commissioning and maintenance activities
simultaneously on various SIMATIC S7 stations and PROFINET devices as a bulk operation
independent of the TIA Portal. For example:
• Searching of the network and creation of a table showing the accessible devices in the
network.
• Flashing of device LEDs or HMI displays to locate a device
• Loading addresses (IP, subnet, gateway) to a device
• Downloading of the PROFINET name (station name) to a device
• Resetting of devices to factory settings (resetting interface parameters)
• Downloading of a 󹪝rmware update to a device
You can 󹪝nd the SIMATIC Automation Tool on the Internet (https://
support.industry.siemens.com/cs/ww/en/view/98161300).
PRONETA
SIEMENS PRONETA (PROFINET network analysis) allows you to analyze the plant network during
commissioning. PRONETA features two core functions:
• The topology overview automatically scans the PROFINET and all connected components.
• PRONETA also scans: con󹪝guration of the station name, IP subnet mask and identi󹪝cation and
maintenance data (I&M1..3)
You can 󹪝nd SIEMENS PRONETA on the Internet (https://
support.industry.siemens.com/cs/ww/en/view/67460624).
Documentation guide
PDC600(F)
Equipment Manual, 12/2023, A5E50502703-AB 9