Siemens SIMATIC NET RUGGEDCOM RSG2100 - 2.3.3 Mounting the Device to a Panel

Installing the Device
2.3.3Mounting the Device to a Panel
2
1
2
3
3
1
Panel/DIN Rail Adapter
2
DIN Rail
3
Screw
Figure2.2 DIN Rail Mounting
2. Install one of the supplied screws on either side of the device to secure the
adapters to the DIN rails.
2.3.3 Mounting the Device to a Panel
For panel installations, the RUGGEDCOM RSG2100 can be equipped with panelDIN
rail adapters pre-installed on each side of the chassis. The adapters allow the device
to be attached to a panel using screws.
To mount the device to a panel, do the following:
1. Place the device against the panel and align the adapters with the mounting
holes.
12
RUGGEDCOM RSG2100
Installation Manual, 11/2022, C79000-G8976-1040-20