Siemens SIMATIC NET RUGGEDCOM RST916C User Manual

Device Management
3.3Inserting/Removing the CLP
Removing the CLP
To remove the CLP, do the following:
NOTICE
Configuration hazard – risk of data loss
After uploading or downloading a file, allow at least twenty seconds before
removing the CLP to ensure the data has been fully transferred.
1. Remove the CLP (or blank insert) from the CLP port. If needed, insert a flat head
screwdriver between the CLP and the chassis to gently pry the CLP out.
2
1
1
Blank Insert
2
CLP
Figure3.1 Removing the CLP
NOTICE
Contamination hazard – risk of dust and dirt entering the CLP slot
When the CLP is not installed, make sure a blank insert (provided with each
device) is installed in its place.
2. Insert a blank insert or a new CLP.
Inserting the CLP
To insert the CLP, do the following:
1. Remove the current CLP (or blank insert) from the device.
RUGGEDCOM RST916C
Installation Manual, 04/2023, C79000-G8976-1490-07
23

Siemens SIMATIC NET RUGGEDCOM RST916C Specifications

General

Brand	Siemens
Model	SIMATIC NET RUGGEDCOM RST916C
Category	Switch
Language	English