Siemens SIMATIC NET SCALANCE W700 Series User Manual

Configuring with Web Based Management
5.6 "Interfaces" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
210 Configuration Manual, 03/2015, C79000-G8976-C267-08
5.6
"Interfaces" menu
5.6.1
Ethernet
5.6.1.1
Overview
Overview of the port configuration
The page shows the configuration for the data transfer for all ports of the device. You cannot
configure anything on this page.
Description
The table has the following columns:
●
Port
Shows the configurable ports. If you click on the link, the corresponding configuration
page is opened.
●
Port Name
Shows the name of the port.
●
Status
Shows whether the port is on or off. Data traffic is possible only over an enabled port.
●
Link
Shows the connection status to the network. With the connection status, the following is
possible:
– Up
The port has a valid link to the network, a link integrity signal is being received.
– Down
The link is down, for example because the connected device is turned off.
●
Mode
Shows the transfer parameters of the port.
●
MTU (Maximum Transmission Unit)
Shows the packet size.

Siemens SIMATIC NET SCALANCE W700 Series Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE W700 Series
Category	Wireless Access Point
Language	English