iii
Connecting TM I/O to PCS 7
C79000-G8076-C710-04
Preface
This manual provides information on hardware components you can use to
interconnect an existing TELEPERM M I/O installation and the process con-
trol system SIMATIC PCS 7.
A combination of corresponding tools and programs enables communication
(Configuration and Operation) with the C&O system WinCC.
The information in this manual enables you to:
• commission the TPM 478-2 interface module
• operate migration rack II with PCS7/TM.
This documentation describes system-specific functions of the TPM 478-2
interface module and the use of migration rack II with PCS7/TM.
Topics included:
• Hardware assembly
• Software installation
• Commissioning
• Configuration
• TPM 478-2 interface module
• Migration rack II
• Technical data, abbreviations list, literatur listing, glossary.
The target group of readers is occupied in programming and process techno-
logy engineering.
Prerequisite is basic knowledge on handling PCs and
working with WinCC/TM.
Also required is knowledge of the process control system TELEPERM M,
PCS7 and SIMATIC S7.
A number of technical descriptions and manuals are available for consolida-
tion of this information. Please refer to the literature index in Appendix C.
Purpose of this
manual
Manual
content
Readers
Prerequisites
To Next Page
Loading...
