4-14
Connecting TM I/O to PCS 7
C79000-G8076-C710-04
.S5_Typ=DA1; Only enter if operating EG driver type 0, 1 or 2 with
CNO=4.
.Kanal=5; Only enter if operating EG driver type 0, 1/KNR=5 or
type 2/KNR=4.
.S5_Typ=DA1; Only enter if operating EG driver type 0, 1/CNO=5 or
type 2/CNO=4.
Kanal=6; Only enter if operating EG driver type 0, 1 or 2 with
CNO=6.
.S5_Typ=DA1; Only enter if operating EG driver type 0, 1 or 2 with
CNO=6.
.Kanal=7; Only enter if operating EG driver type 0, 1/KNR=7 or
type 2/CNO=6.
.S5_Typ=DA1; Only enter if operating EG driver type 0, 1/KNR=7 or
type 2/CNO=6.
The configuration must be adapted every time a driver is installed or unin-
stalled. However, alternatively it is possible to initially configure all channels
and drivers and next link the unused drivers to a source in order to switch
over their manual/auto mode in synchronism to the other drivers.
Also, all TM_EG blocks assigned to one module must follow each other im-
mediately in the same block. They must be switch on or off all at once.
Confi
uration
To Next Page
Loading...
Need help?
General
