Siemens Simatic S7-1500

Software section
3.4 Loading the project into the programming device
S7-1500
110 Getting Started, 05/2014, A5E03981761-AC
3.4
Loading the project into the programming device
3.4.1
Load CPU to project
Introduction
You can create a new station including the actual values from the hardware configuration
and the user program.
Procedure
1. Open the dialog for loading from the CPU.
2. Select the interface with which the programming device is connected to the CPU. The
search for accessible nodes starts automatically.
3. Load the CPU in the project.