Siemens Simatic S7-1500 - Assigning Names for ET 200

Software section
3.1 Creating the project and hardware
S7-1500
Getting Started, 05/2014, A5E03981761-AC
47
3.1.9
Assigning names for ET 200
Introduction
In the following section, you will assign project-specific names to the distributed I/O.
Procedure
1. Select ET 200SP.
2. Under
Properties > General
in the inspector window, enter the name
"Valve_Control_Unit" in the "Name" field.
3. Select ET 200MP and enter the new name "Mixer_Conveyor_Control_Unit".
Result
You have assigned the project-specific names.